Mechanical Technology: Mechanical Design and Drafting
Curriculum Requirements
As a student in this program, you are required to complete a minimum of 71 credit hours with a grade point average of not less than C (2.0). All technology students take a common core of courses during the first semester along with an introductory course in their chosen degree program. After the first semester, it is possible to transfer from one technology degree program to another without loss of credit.
All associate degree programs require ENG 101 Freshman English and ENG 102 Introduction to Literature. You must pass skills assessment for entrance into these courses. If you are well prepared, you may substitute ENG 104 Freshman English I Honors and ENG 105 Freshman English II Honors for ENG 101 and ENG 102. (If you are considering the English Honors sequence, you should consult the Director of Honors by calling 585.394.FLCC, ext. 7367.) For this degree program, you must successfully complete the following:
Humanities
- ENG 101 Freshman English AND ENG 102 Introduction to Literature OR ENG 104 Freshman English I Honors AND ENG 105 Freshman English II Honors
Social Science
- 6 credit hours of Social Science Electives
Mathematics
- 6 credit hours from the following Mathematics Electives:
- MAT 145 College Algebra
- MAT 152 Pre-Calculus
- MAT 271 Calculus I
- MAT 272 Calculus II
Physics
- PHY 118 College Physics I AND PHY 119 College Physics II OR PHY 151 General Physics I AND PHY 152 General Physics II
Mechanical Design and Drafting Technology
- TECH 101 Materials and Processes I
- TECH 104 Materials and Processes II
- TECH 205 Engineering Drawing III
- TECH 206 Engineering Drawing IV
- TECH 217 Dynamics and Strength of Materials
- TECH 220 Machine Design I
- TECH 221 Machine Design II
Technology
- TECH 105 Engineering Drawing I
- TECH 106 Engineering Drawing II (2D AutoCAD)
- TECH 115 Technology Freshman Seminar
- TECH 216 Statics and Strength of Materials
- TECH 122 Electronics Theory I
Approved Technology Electives
- 6 credit hours from the following Technology Electives:
- TECH 123 Digital Electronics
- TECH 219 3D AutoCAD
- TECH 250 Technology Co-Op
Health/Physical Education
- 4 credit hours of Health/Physical Education (PE) Electives
