A.A.S. MECHANICAL DESIGN & DRAFTING ) FLCC

All associate degree programs require English 101 Freshman English and English 102 Introduction to Literature. Students must pass skills assessment for entrance into these courses. Students who are well prepared may substitute ENG 104 English I Honors and ENG 105 English II Honors for ENG101 and ENG102. Students who are considering the English Honors sequence should consult the Director of Honors.

All technology students take a common core of courses during the first semester along with an introductory course in their chosen degree program. After the first semester, it is possible for the student to transfer from one degree program to another without loss of credit.

Humanities	ENG 101 Freshman English ENG 102 Introduction to Literature OR ENG 104 English I Honors ENG 105 English II Honors
Social Science	6 credit hours
Mathematics	6 credit hours from the following electives: MAT 145 College Algebra MAT 152 Pre-Calculus MAT 271 Calculus I MAT 272 Calculus II
Physics	PHY 118 College Physics I PHY 119 College Physics II OR PHY 151 General Physics I PHY 152 General Physics II
Mechanical Design & Drafting Technology	TECH 101 Materials and Processes I
	TECH 104 Materials and Processes II
	TECH 205 Engineering Drawing III
	TECH 206 Engineering Drawing IV
	TECH 217 Dynamics and Strength of Materials
	TECH 220 Machine Design I
	TECH 221 Machine Design II
Technology	TECH 105 Engineering Drawing I
	TECH 106 Engineering Drawing II (2D AutoCAD)
	TECH 115 Technology Freshman Seminar
	TECH 216 Statics and Strength of Materials
	TECH 122 Electronics Theory I
Approved Technology Electives	6 credit hours from the following: TECH 123 Digital Electronics TECH 219 3D AutoCAD TECH 250 Technology Co-Op
Health/Physical Education Elective	4 credit hours